ft14 steel equivalent to cr2 steel Related introduction

  1. Indian Standard COLD REDUCED LOW CARBON STEEL

    Indian Standard COLD REDUCED LOW CARBON STEEL SHEET AND STRIP (Fijth Revision) 1 SCOPE This standard covers therequirements of cold reduced low carbon steel sheets and strips for bending and drawing purpose and where the surface is of prime importance. It covers sheets and strips up to 4.50 mm thick, both in coil form and cut lengths. 2 REFERENCES

  2. IS 513 (2008): Cold reduced low carbon steel sheets and …

    AMENDMENT NO. 1 JULY 2010 TO IS 513 : 2008 COLD REDUCED LOW CARBON STEEL SHEET AND STRIP ( Fifth Revision ) (Page 1, clause 3) ― Insert ‘CR0’, before ‘CR1’.(Page 1, clause 4.3) ― Substitute the following for the existing first para: ‘Sheets and strips of CR2, CR3, CR4 and CR5 grade shall be supplied in annealed and skin passed condition.

  3. FT14 and FT14HC SG Iron Ball Float Steam Traps (1' …

    FT14 and FT14HC SG Iron Ball Float Steam Traps (1" HC, 1¼", 1½" and 2") Description The FT14 and FT14HC are iron bodied ball float steam traps having stainless steel working internals and integral automatic air venting facility. These traps are supplied with horizontal screwed connections only and can be maintained without disturbing the ...

  4. Uddeholm Vanadis 4 Extra SuperClean

    Protect the steel and heat through to 900°C (1650°F). Cool in the furnace at 10°C (20°F) per hour to 650°C (1200°F), then freely in air. After rough machining the tool should be heated through to 650°C (1200°F), holding time 2 hours. Cool slowly to 500°C (930°F), then freely in air.

  5. Carbon and stainless steel pipes/tubes for mechanical ...

    steel pipes/tubes in accordance with DIN 2394 (EN 10305-3) Steel grades · St 34-2 · St 37-2 Supplied in the BKM-soft condition (E220+CR2 and E260+CR2), suitable for limited cold bending Dimensions · 10 – 120 mm OD · 1 – 5 mm wall Special options manufactured to order · Dimensions up to 200 mm OD and 8 mm wall thickness · Steel grades St 44-2 and

Online Consultation